There is no sound from the center speaker.

If you connect the DVD player, etc. to the digital input jack on this system, check the audio setting (for digital audio output) of the component (page 7).

Make sure the sound field function is on (press SOUND FIELD +/–).

Select the CINEMA STUDIO EX mode (page 18).

Adjust the speaker level (page 26).

There is no sound or only a very low-level sound is heard from the surround speakers.

If you connect the DVD player, etc. to the digital input jack on this system, check the audio setting (for digital audio output) of the component (page 7).

Make sure the sound field function is on (press SOUND FIELD +/–).

Select the CINEMA STUDIO EX mode (page 18).

Adjust the speaker level (page 26).

The surround effect cannot be obtained.

Make sure the sound field function is on (press SOUND FIELD +/–).

The remote does not function.

Point the remote at the remote sensor on the control center.

Remove any obstacles in the path between the remote and the control center.

Replace both batteries in the remote with new ones, if they are weak.

Make sure you select the correct function on the remote.

When the following message appears in the display

“UNLOCK”

You select DVD, AUX or SAT as the function and no component is connected to the digital input jacks.

The component is correctly connected, but the component is turned off or the playback has not started.

“PROTECT”

The speaker cords are short-circuited (page 11).

p Turn off the power, then reconnect the speaker cords correctly.

The system heats up because the system was used for a long time with loud volume.

p Turn off the power and leave the system for a while.

p Turn down the volume.

Reference sections for clearing the system’s memory

To clear

See

All memorized settings

page 14

 

 

Information Additional

29GB