Installing the control center on the wall

Attach the jack cover. Fasten the screws (not supplied) to the wall at the same height 80 mm apart. The screws should protrude by 5 to

6 mm.

80 mm

5 to 6 mm

Notes

Use the screws that matches the wall material and strength.

Install the control center on a vertical and flat wall where reinforcement is applied. Do not instal the control center if the wall is not vertical, flat or strong enough.

Contact a screw shop or installer regarding the wall material or screws to be used.

After the control center has been used for long time on the wall, the wall behind or above the control center may discolor or peel off by radiation of heat from the control center depending on the wall material.

Sony will refrain from any responsibility on the accident or damage caused by improper installation, lack of durability of the wall or screws improper operation, natural calamity, etc.

When you disconnect or connect the cords, take the control center down from the wall.

Started Getting

Remove the seals covering the hanging holed. Hang the control center on the screws. Push the control center tightly against the wall.

4.2 mm

9.2 mm

8:Connecting the AC power cord

After connecting the components, connect the AC power cord of the subwoofer to a wall outlet.

AC power cord

Subwoofer

CONTROL

b

To a wall outlet

13GB