Setting Up the LCD Projection TV
VCR and Cable Box
Before connecting a cable box, see “Using CableCARD” on page 56.
Use this hookup if:
❑Your cable TV company scrambles some channels, but not all of them (pay channels vs. regular cable channels) and you need to use a cable box.
❑You want to enjoy the Twin View feature.
With this setup you can:
❑Use the LCD projection TV’s remote control to change channels on your cable box when the signal is scrambled. To program your Sony remote control to operate your cable box, see “Programming the Remote Control” on page 62.
❑Use the LCD projection TV’s remote control to change channels on your LCD projection TV when the signal is not scrambled. Your LCD projection TV’s tuner provides a better signal than the cable box.
❑Use the Twin View feature. (When all channels are routed through your cable box, only one signal is sent to the LCD projection TV, so you cannot use the Twin View feature.)
Disconnect all power sources before making any connections.
1Connect the CATV cable to the single (input) jack of the splitter.
2Using a coaxial cable, connect one of the splitter’s two output jacks to the LCD projection TV’s CABLE jack.
3Using a coaxial cable, connect the splitter’s other output jack to the cable box’s input jack.
4Using a coaxial cable, connect the cable box’s output jack to the VCR’s RF input jack.
5Using an A/V cable, connect the cable box’s A/V output jacks to the LCD projection TV’s A/V input jacks.
6Using an A/V and S VIDEO cables, connect the VCR’s AUDIO and S VIDEO OUT jacks to the LCD projection TV’s AUDIO and S VIDEO IN input jacks.
7Run Auto Program, as described in “Setting Up the LCD Projection TV Channel List” on page 58.
✍To view scrambled channels, tune the LCD projection TV to the channel the cable box is set to (usually channel 3 or 4) and then use the cable box to switch channels.
40