Setting Up the LCD Projection TV
Two VCRs for Tape Editing
Using
S VIDEO jacks?
See page 38.
Cables are often
VCR (playback)
If you connect two VCRs, you can record from one VCR to the other while using your LCD projection TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1Using A/V cables, connect the playback VCR’s AUDIO and VIDEO OUT jacks to the recording VCR’s AUDIO and VIDEO IN jacks.
2Using A/V cables, connect the recording VCR’s AUDIO and VIDEO OUT jacks to the LCD projection TV’s AUDIO and VIDEO IN jacks.
Rear of LCD projection TV | ||
| VIDEO IN | |
1 | 3 | 4 |
S VIDEO |
| 7 |
VCR (recording) |
| |
|
| |
VIDEO |
|
|
L(MONO) |
|
|
AUDIO |
|
|
R |
|
|
VIDEO (yellow)
A/V cable (not supplied) | A/V cable (not supplied) |
✍To perform tape editing, set the LCD projection TV to the video input intended for playback by pressing TV/VIDEO on the remote control.
✍You may need to change the video input on your VCR. Consult your VCR’s operating manual for instructions.
✍If your VCRs have S VIDEO jacks: For best picture quality, use an
S VIDEO connection instead of the yellow video cable on your combined A/V cable.
Using an S VIDEO cable, connect the playback VCR’s S VIDEO OUT jack to the recording VCR’s S VIDEO IN jack. S VIDEO does not provide audio, so audio cables must be connected to provide sound.
✍You cannot record signals from equipment connected to the Y, PB, PR input.
42