ProblemCause/Remedy

Picture flashes initially when changing to HDMI mode or when switching on the TV in HDMI mode

•This is probably caused by the authentication process between HDMI equipment and the TV. It does not indicate a malfunction.

A white oval image appears on the screen

•This is due to strong light reflecting off both the TV screen and reflections coming from behind the screens.

•Position your TV away from strong ambient light or sunlight, or lower any ambient lights.

Sound

Problem

Cause/Remedy

No sound, but good picture

• Press 2 +/– or % (Mute).

 

•

Check that “Speaker” is set to “On” in the “Set-up” menu (page 32).

 

 

 

Noisy sound

•

See “Picture noise” causes/remedies on page 53.

 

 

 

Channels

Problem

Cause/Remedy

 

 

The desired channel cannot be

• Switch between digital and analogue mode and select the desired digital/

selected

analogue channel.

 

 

Some channels are blank

• Scrambled/Subscription only channel. Subscribe to the Pay Per View

 

service.

 

• Channel is used only for data (no picture or sound).

 

• Contact the broadcaster for transmission details.

 

 

Digital channels are not

• Contact a local installer to find out if digital transmissions are provided in

displayed

your area.

 

• Upgrade to a higher gain aerial.

 

 

General

ProblemCause/Remedy

The TV turns off automatically (the TV enters standby mode)

•Check if the “Sleep Timer” is activated, or confirm the “Duration” setting of “On Timer” (page 31).

•If the inside of the TV grows warm while Cooling Mode is set to “High”, the TV automatically switches to standby mode.

(When Cooling Mode is set to “Normal” under the same conditions, the mode switches to “High”, the cooling fan starts, and a loud whirring noise may be heard.)

•If no signal is received and no operation is performed in the TV mode for 10 minutes, the TV automatically switches to standby mode.

The TV turns on automatically

•

Check if the “On Timer” is activated (page 31).

 

 

 

Some input sources cannot be

•

Select “AV Preset” in the “AV Set-up” menu and cancel “Skip” of the input

selected

 

source (page 34).

 

 

 

54 GB