✍ You cannot record signals from equipment connected to the Y, PB, PR input.
You may need to change the video input on your VCR. Consult your VCR’s operating manual for instructions.
To perform tape editing, set the projection TV to the video input intended for playback by pressing TV/VIDEO on the remote control.
✍
✍
✍ If both VCRs have an S VIDEO jack, you can use the S VIDEO connection instead of the yellow video cable on a combined A/V cable.
To use an S VIDEO cable, connect the VIDEO OUT jack of the playback VCR to the VIDEO IN jack of the recording VCR. Since S VIDEO does not provide audio, you must still connect audio cables to provide sound.
If you connect two VCRs, you can record from one VCR to the other while using your projection TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1 Using AUDIO and VIDEO cables, connect the playback VCR’s AUDIO and VIDEO OUT jacks to the recording VCR’s Audio and Video IN jacks.
2 Using AUDIO and VIDEO cables, connect the recording VCR’s AUDIO and Video OUT jacks to the projection TV’s AUDIO and VIDEO IN jacks.
Rear of projection TV
VCR (recording)
AUDIO-R (red) AUDIO-L (white) VIDEO (yellow)
VMC-810S/820S (not supplied)

Installing and Connecting the Projection TV

Connecting Two VCRs for Tape Editing

VCR (playback)

22