Press ENTER.

Other Information

To program video equipment

1 Open the panel of the remote control.

2 Move the slide switch to the desired component type. 3 Press CODE SET inside the panel.

You must perform step 4 within 10 seconds of step 3, or you must start again from step 3.

4 Close the panel and enter the three-digit manufacturer’s code number using the 0-9buttons.

5

6 To check if the code number works, aim the projection TV’s remote control at the component, open the panel, and press the green POWER button. If it responds, the programming is completed. If not, try using the other codes listed for that manufacturer.

Tips

If more than one code number is listed, try entering them one by one

until you come to the correct code for your component.

If you enter a new code number, the code number you previously entered at that setting is erased.

In some rare cases, you may not be able to operate your component with the Sony remote control. In this case, use the component’s own remote control unit.

72