DYNAMIC CONVERGENCE ADJUSTMENT

Before performing this adjustment, perform Horizontal and Vertical Static Convergence Adjustment.

1.Slightly loosen defl ection yoke screw.

2.Remove defl ection yoke spacers.

3.Move the defl ection yoke for best convergence as

shownRGBbelow:BGR

GRBBRGRBGRB

BGRRGB

RGBRBGRBRGB

4.Tighten the defl ection yoke screw.

5.Install the defl ection yoke spacers.

SCREEN-CORNER CONVERGENCE

1. Affi x a permalloy assemblyb correspondinga toathe misconvergedbareas:

dcacmisconvergence-d:screen-cornrd

KV-20S90 / 21SE43C

2-3. FOCUS

1. Adjust FOCUS control for best pictures.

Focus (FV)

Screen (G2)

2-4. SCREEN (G2)

1.Input a dot pattern.

2.Set the PICTURE and BRIGHTNESS controls at minimum and COLOR control at normal.

3.Adjust SBRT, GCUT, BCUT in service mode with an oscilloscope as shown below so that voltages on the red, green, and blue cathodes are 170 ± 2 VDC.

170 ± 2 VDC pedestal

GND

4.Observe the screen and adjust SCREEN (G2) VR to obtain the faintly visible background of dot signal.

— 12 —

Page 12
Image 12
Sony KV-21SE43C, KV-20S90 service manual Dynamic Convergence Adjustment, SCREEN-CORNER Convergence, Focus, Screen G2