– 13 –
KV-T29SN81
RM-870
2-7. PICTURE TUBE REMOVAL

NOTE : The picture tube for this model is upside-down and the position for the anode-cap and

tension spring is changed accordingly

b
b
2Using a thumb press down then pull up the rubber cap firmly in the direction
indicated by the arrow b.
3When one side of the rubber cap is separated from the anode button, the anode-
cap can be removed by turning up the rubber cap and pulling it up in the direc-
tion of the arrow c.
c
Anode button

•HOW TO HANDLE AN ANODE-CAP

1Do not damage the surface of anode-caps with sharp shaped objects.
2Do not press the rubber too hard so as not to damage the inside of anode-caps.
A metal fitting called the shatter-hook terminal is built into the rubber.
3Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
Anode Button
2 A board
4 C board
6 Deflection yoke
5 VM board
Cushion
7 Four screws
(Tapping screws)
1 Anode cap
3 F1 board
•REMOVAL OF ANODE-CAP

NOTE : After removing the anode, short circuit the anode of the picture tube and the an-

ode cap to the metal chassis, CRT shield or carbon paint on the CRT.

•REMOVING PROCEDURES
1Turn up one side of the rubber cap in the direction indicated by the arrow a.
a
a