*This system supports FAT16 and FAT32, but some USB device may not support all of these FAT. For details, see the operating instructions of each USB device or contact the manufacturer.

Tuner

There is severe hum or noise. (“TUNED” or “ST” flashes in the display)

Set the proper band and frequency (page 22).

Connect the antenna properly (page 12).

Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend that you connect a commercially available external antenna.

The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully.

Locate the antennas as far away from the speaker cords as possible.

Try turning off the surrounding electrical equipment.

A stereo FM program cannot be received in stereo.

Press FM MODE on the remote repeatedly until “MONO” disappears from the display.

Tape deck

The tape does not record or playback, or there is a decrease in sound level.

The tape heads are dirty (see “Cleaning the tape heads” on page 51).

The record/playback heads are magnetized (see “Demagnetizing the tape heads” on page 51).

The tape does not erase completely.

The record/playback heads are magnetized (see “Demagnetizing the tape heads” on page 51).

There is excessive wow or flutter, or the sound drops out.

The capstans or pinch rollers are dirty (see “Cleaning the tape heads” on page 51).

Noise increases or the high frequencies are erased.

The record/playback heads are magnetized (see “Demagnetizing the tape heads” on page 51).

The tape does not record.

No tape is loaded. Load a tape.

The tab has been removed from the tape. Cover the broken tab with adhesive tape (page 51).

The tape has reeled to the end.

The system cannot play back the reverse side of the tape in tape deck.

The system only can play back front side of the tape in tape deck. This is not a malfunction.

The system cannot record the reverse side of the tape in tape deck.

The system only can record front side of the tape in tape deck. This is not a malfunction.

The recorded sound has echo effect.

Before you start recording, press FLANGER, DELAY or CHORUS repeatedly until “FLANGER”, “DELAY” and “CHORUS” disappear from the display.

Continued l

Information Additional

47GB