To

Operation

 

 

Record partway through the

Press N • PLAY, > • CUE • AMS or . •

previous recording

REVIEW • AMS to find the beginning of the

 

material to be recorded, and then press X • PAUSE.

 

Press REC so that the recorder changes to recording

 

pause.

 

Press X • PAUSE again to start recording.

 

 

Pause1)

Press X • PAUSE while recording.

 

Press X • PAUSE again to resume recording.

 

 

Remove the MD

x • STOP to stop recording, check if “TOC Edit”

 

has disappeared from the display, and then open the

 

lid.

 

 

1)The REC indicator flashes during recording pause. Track marks are not added while recording with microphone, even when the recorder is paused.

If the recording does not start

•Make sure the recorder is not locked (page 12).

•Make sure the MD is not record-protected (page 46).

•Premastered MDs cannot be recorded over.

To know the recording condition

The REC indicator lights up or flashes according to the recording condition.

Recording

REC indicator

condition

 

 

 

While recording

lights up

 

flashes according

 

to the loudness of

 

the source while

 

recording with a

 

microphone

 

(voice mirror)

 

 

Recording standby

flashes

 

 

Less than 3

flashes slowly

minutes’ recording

 

time available

 

 

 

A track mark has

goes off

been added1)

momentarily

1)Except when track marking was done manually or automatically using Auto Time Mark (page 24).

Notes

•For long recordings, it is recommended that you power the recorder from a house current using an optional AC power adaptor AC- E30HG (page 43).

•The lid will not open during recording or until “TOC Edit” disappears from the display after the recording has completed.

•If the power supply is disrupted (i.e. the batteries are removed or becomes exhausted or the optional AC power adaptor is disconnected) during a recording operation, or while “TOC Edit” appears in the display, then it will not be possible to open the lid until power is restored and the x • STOP button is pressed.

•“Data Save” or “TOC Edit” flashes while data of the recording (the track’s start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display. If you do, the material recorded up to that point will not be saved to the disc.

•When you record through the microphone, the various sounds made by the recorder may also be recorded.

•The built-in microphone do not operate whenever an optional microphone is connected into the MIC (PLUG IN POWER) jack on the recorder.

•The built-in microphone do not operate whenever an optical cable or a line cable (not supplied) is connected into the LINE IN (OPTICAL) jack on the recorder.

15