Symptom | Cause/Remedy |
|
|
The group | • While using a disc without group setting, an attempt was made to |
function does not | select some |
operate. | , Use a disc with group setting. |
|
|
A track cannot be | • This is due to the MiniDisc system limitations. If the total number |
recorded to a new | of characters for the disc can store exceeds approximately 1,700, a |
group. A new | new group cannot be created even though group mode is on. It is |
group cannot be | also impossible to make group settings at this time. |
created. |
|
|
|
Symptom | Cause/Remedy |
|
|
The display | • The recorder was disconnected from the power source. |
window is not | , Let the recorder sit for a while, or disconnect the power source, |
normal. | reconnect it, and then press any of the operation buttons. |
|
|
The recorder does | • The volume is low. |
not work or works | , Turn up the volume. |
poorly. | • No disc is inserted. |
| , Insert a recorded disc. |
| • The HOLD function is turned on (“HOLD” appears in the display |
| when you press an operation button on the recorder). |
| , On the recorder, disable HOLD by sliding the HOLD switch to |
| the opposite direction of the arrow. |
| • The lid is not firmly closed. |
| , Close the lid until it clicks. |
| • Moisture has condensed inside the recorder. |
| , Take the MD out and leave the recorder in a warm place for |
| several hours until the moisture evaporates. |
| • The dry batteries are weak (“LOW BATT” flashes or nothing |
| appears). |
| , Replace the dry batteries with the new one (page 12), or |
| connect the AC power adaptor to the recorder. |
| • The dry battery have been inserted incorrectly. |
| , Insert the battery correctly (page 12). |
| • The disc is damaged or does not contain proper recording or |
| editing data. |
| , Reinsert the disc. Rerecord the disc. If the error message still |
| appears, replace it with another disc. |
| • A disc with no track is inserted. |
| , Replace to another disc. |
|
|
52