The recorder does | • The record protect tab is opened. | |
not work or works | , Slide the record protect tab closed (page 46). | |
poorly. | • While operating, the recorder received a mechanical shock, too | |
| much static, abnormal power voltage caused by lightning, etc. | |
| , Restart the operation as follows. | |
| 1 | Take out batteries or disconnect all the power sources. |
| 2 | Leave the recorder for about 30 seconds. |
| 3 | Insert batteries or connect the power source. |
|
|
|
Messages
If the following messages flash in the display window, check the chart below.
Error message | Meaning/Remedy |
|
|
BLANKDISC | • An MD with no recording on it is inserted. |
| , Insert a recorded MD. |
|
|
BUSY | • You tried to operate the recorder while it was accessing the |
| recorded data. |
| , Wait until the message goes out (in rare cases, it may take |
| minutes). |
|
|
DISC FULL | • The remaining recording time on the disc is 12 seconds (SP), 24 |
| seconds (LP2 or monaural), 36 seconds (LP4), or less. |
| , Replace the disc. |
|
|
ERROR | • There is an internal malfunction in the system. |
| , Restart the operation by doing steps 1 to 3 on page 53. If the |
| message appears again, please consult your nearest Sony |
| dealer. |
|
|
GroupFULL | • You tried to create a 100th group while editing. |
| , You can create only up to 99 groups on a disc. Keep the group |
| number within 99. |
|
|
Hi DC in | • Voltage of the power supply is too high (The recommended AC |
| power adaptor or the recommended car battery cord is not used). |
| , Use the recommended AC power adaptor (not supplied) or the |
| car battery cord (not supplied). |
|
|
HOLD | • The recorder is locked. |
| , Slide HOLD against the arrow to unlock the recorder. |
|
|
LOW BATT | • Batteries are weak. |
| , Replace the dry batteries (page 12). |
|
|
MEM OVER | • You tried to record with the recorder placed where it receives |
| continuous vibration. |
| , Put the recorder on a stable place, and start recording again. |
|
|
53