Symptom | Cause/Remedy | |
|
| |
“TR FULL” appears | • This is due to the MiniDisc system limitation. When 254 tracks | |
even before the disc | have been recorded on the disc, “TR FULL” appears regardless | |
has reached the | of the total recorded time. More than 254 tracks cannot be | |
maximum recording | recorded on the disc. | |
time (60, 74, or 80 | , To continue recording, erase unnecessary tracks. | |
minutes) and the | ||
| ||
recording cannot be |
| |
done. |
| |
|
| |
The remaining | • This is due to the MiniDisc system limitation. Tracks of under | |
recording time does | 12 seconds (in SP stereo), 24 seconds (in LP2 stereo mode or | |
not increase even | monaural), or 48 seconds (in LP4 stereo mode) in length are not | |
after erasing | counted and so erasing them may not lead to an increase in the | |
numerous short | recording time. | |
tracks. |
| |
|
| |
|
|
Symptom | Cause/Remedy |
An MD is not | • Repeat play is selected. |
played normally. | , Use MENU on the recorder or press P MODE/ on the |
| remote control to change back to the normal play. |
•Playback mode is changed.
,Use MENU on the recorder or press P MODE/ on the remote control to change back to the normal play.
An MD is not | • Disc playing stopped before it came to the last track. |
played from the | , Press N for 2 seconds or more to start playing, or press the |
first track. | control towards . repeatedly on the remote. |
|
|
Playback sound | • The recorder is placed where it receives continuous vibration. |
skips. | , Put the recorder on a stable place. |
| • A very short track may cause sound to skip. |
| , Try not to create a track under one second long. |
|
|
Sound has a lot of | • Strong magnetism from a television or such device is interfering |
static. | with operation. |
| , Move the recorder away from the source of strong magnetism. |
|
|
The volume of the | • The track was recorded in analog (When recorded in digital, the |
recorded track is | recording level will be automatically adjusted as same as the sound |
low. | source), or you used a connecting cord with an attenuator. |
| , Use a correct connecting cord. |
| • The recording level was low. |
| , Adjust the recording level manually when recording. |
|
|
Volume cannot be | • AVLS is on. |
turned up. | , Release AVLS settings (page 57). |
69