Sony MZ-R91 Storing phrases frequently used in labeling (Phrase Bank), Storing phrases frequently used in labeling, Note, Notes, 35-GB, Jog lever, Available characters

2 To label a track, press x.

To label a disc, press the control towards . or towards N • > until “ : Name” flashes in the display, then press x.

The track or disc is ready to be labeled.

3 Follow steps 4 to 6 of “Labeling a disc during stop” (page 34).

To cancel labeling, press DISPLAY for 2 seconds or more.

Note

When the recording is stopped while labeling a track or a disc during recording, or when the recording moves on to the next track while labeling a track, the input at that point is entered automatically.

Available characters

•Capital and small letters of the English alphabet•Numbers 0 to 9

•! " # $ % & ( ) * . ; < = > ? @ _ ` + – ' , / : _ (space)

Relabeling recordings

Follow the steps corresponding to the labeling method until the disc or track is ready to be labeled. Enter a new character over the one you want to change, then press the jog lever (keep pressing xfor 2 seconds or more on the remote control).

Notes

•You cannot relabel premastered MDs or label MDs that have not been recorded.

•The recorder is able to display, but cannot label using Japanese “Katakana” characters.

•The recorder cannot rewrite a disc or track name of more than 200 letters that was created by another device.

Storing phrases frequently used in labeling (Phrase Bank)

Phrases that you often use in track or disc labeling can be stored in the recorder’s memory. There are two ways to store phrases: storing a phrase while performing the labeling procedure, or storing a phase using the EDIT menu. Approximately 40 phrases of about 10 characters each (with a total character count of about 600) can be stored in the phrase bank. The actual number will depend on the length of each phrases.

On the recorder

Jog lever

N

X

./>

Storing phrases while labeling a track or disc

1 Do the procedure “Labeling recordings” (page 32) to enter a phrase.2 After entering the phrase, press Xfor2 seconds or more.

“Entry!” appears in the display and the cursor flashes after the phrase you just stored. You can then continue with labeling operation.

35-GB