1 Insert a recordable disc into the recorder.
2 Make connections as follows.
1Connect the dedicated USB cable to the recorder and to the computer.
2Make sure the recorder is stopped and HOLD is released.
3 Check the connections.
When the connections have been properly made, “PC –
When you unplug the dedicated USB cable from the computer or remove the disc from the recorder
Be sure to remove the recorder or the disc as follows. If not, damage to the data may occur.
1 Make sure that “REC” is not displayed in the display window of the recorder.
2 Press x on the recorder.
“EJECT DISC OK” appears in the display.
Depending on the conditions, it may take some time until “EJECT DISC OK” appears in the display.
3 Unplug the dedicated USB cable from the computer or remove the disc from the recorder.
Notes
•If you use the recorder connected to the computer, it is recommended that you insert a new alkaline dry battery as a precaution against power failures, disconnection of the dedicated USB cable or other unforeseen occurrences. We do not assure the results should there be a
•If you disconnect the dedicated USB cable from the recorder and want to reconnect it, make sure to wait at least 2 seconds before connecting it again.
•Make sure to place the recorder at a stable,
•Make sure not to connect the recorder to your computer during recording or playing.
•The system may malfunction if your computer changes to system suspend, sleep, or hibernation mode while connecting to the recorder. Make sure to disable any changes to suspend, sleep, or hibernation mode.
•Make sure not to connect the recorder and the computer through a USB hub.
•When the recorder is connected to a computer, power (bus power) is supplied to the recorder through the computer’s USB port. If the computer (a laptop PC, for example) is operating on battery power, this connection may cause the computer’s battery to drain. It is thus recommended to use the computer with an AC power adaptor.
•We do not ensure
61