This is the Internet version of the user’s guide. © Print only for private use.

Charging the battery

•When the battery needs to be charged, a beep is heard. The indicator light (on the top of your P910a) flashes red and a battery low message appears on the screen.

•The battery can be charged whenever you want. The P910a performance is not affected. However, using your P910a while charging increases the charging time.

To charge the battery

The P910a can be charged either when it is switched on or off.

1.Make sure the battery is inserted in your P910a and the cover is closed.

2. Connect the charger to

the P910a at the base of the phone by the flash symbol. The charger

plug flash symbol must face upwards.

3. Connect the charger to the mains.

4. Wait approximately 4 hours or until the battery meter on the screen is full and the indicator on the top of the P910a shows a steady green light.

5. Remove the charger by tilting the plug upwards.

Tip You can also use other battery chargers that have been supplied with other Sony Ericsson mobile phones using the same connector plug, for example, T300 or P900.

Note When the battery is completely discharged, or new, it may take up to 30 minutes before the battery icon appears on the screen.

Care instructions

Your P910a is a highly sophisticated electronic device. To get the most out of it, please make sure that you follow this advice:

• Keep the P910a in its carry case when not using it.

Charging is indicated by the battery icon on the screen pulsing continuously, and the indicator at the top of the P910a showing a steady red light (or green, if the P910a is switched on).

See also ‘Battery Use and Care’ on page 186.

•Use a lightly moistened cloth when you clean the screen.

•Use only the stylus provided to tap the screen.

13 Getting to know your P910a