Remote ModeSelects the Remote Commander mode.TV: The Sony display’s or the TV’s commanderPJ: The Sony projector’s commanderOff: Disables the remote control.

Note

When you change the Remote Commander mode, use the buttons on the display unit. You cannot change the Remote Commander mode with the Remote Commander.

For details, see “Using Other Remote Commander Models” on page 49 (GB).

Remote Only

Select On to disable the control buttons on the display unit. The display can only be controlled with the Remote Commander.

To cancel the Remote Only mode, set Remote Only to Off with the Remote Commander.

Note

The setting in this item is still retained when the AC power cord is disconnected or when you turn the display on/off with the Remote Commander.

Input Select menuThis menu is used to switch the input signal.

For details on switching the input signal, see “Switching the Input Signal” on page 26 (GB).

Unit Status menuThis menu is used for displaying the internal status of the display unit.

 

 

U n i t

S t a t u s

 

 

 

 

M o d e l N a m e :

P F M - 5 0 C 1

 

 

S e r i a l N u m b e r :

2 0 0 0 0 0 1

 

 

O p e r a t i o n T i m e :

0 0 0 0 1 H

 

 

S o f t w a r e V e r s i o n :

1 . 0 0

 

 

T e m p e r a t u r e :

 

O K

 

 

F a n :

 

 

O K

 

 

S y n c M o d e

:

H / C o m p

 

 

,

t o s e l e c t

i t e m

 

 

 

 

 

 

 

 

Model NameIndicates the model name.Serial NumberIndicates the serial number.

Using On-screen Menus

Operation TimeIndicates the total number of hours of operation.

Note

The standby mode is not counted as part of the Operation Time.Software VersionIndicates the system software version.TemperatureIndicates whether the internal temperature of the display unit is normal.OK: NormalNG: Unusual

When the internal temperature is unusual, NG is displayed and the item flashes in red. The STANDBY indicator on the 1 (standby) switch / indicator section also flashes.

Note

When the ventilation holes are blocked or the display is used in a place with poor ventilation, “NG” may be displayed, flashing in red. In this case, check that the ventilation holes are not blocked and install the display unit in a well ventilated location. If the message is still shown, contact your authorized Sony dealer.

When the STANDBY indicator flashes or NG is indicated, see “Self-diagnosis Function” on page 47 (GB).

Fan

Cooling fans are built into this display unit. This item indicates whether the cooling fans work properly.

OK: Normal

NG: Unusual

When the cooling fans are not working normally, NG is displayed and the item flashes in red. The STANDBY indicator on the 1 (standby) switch / indicator section also flashes.

Notes

•If “NG” is displayed, flashing in red, contact the dealer from whom you purchased the unit, or your nearest Sony Service Center.

When the STANDBY indicator flashes or NG is indicated, see “Self-diagnosis Function” on page 47 (GB).

•The cooling fans detect the display unit’s internal temperature and control the fan rotation. If the ambient temperature is high, the fan speed increases and the fan noise will be louder.

25 (GB)