Step 5: Preparing the Remote

You can control the recorder using the supplied remote. Insert two R6 (size AA) batteries by matching the 3 and # ends on the batteries to the markings inside the battery compartment. When using the remote, point it at the remote sensor on the recorder.

bNotes

Controlling TVs with the remote

You can adjust the remote’s signal to control your TV.

bNotes

•Depending on the connected unit, you may not be able to control your TV with some or all of the buttons below.

•If you enter a new code number, the code number previously entered will be erased.

Number buttons

TV/DVD

• If the supplied remote interferes with your other

Sony DVD recorder or player, change the

command mode number for this recorder

(page 23).

• Use the batteries correctly to avoid possible

leakage and corrosion. Should leakage occur, do

not touch the liquid with bare hands. Observe the

following:

– Do not use a new battery with an old battery, or

TV 2 +/–

DISPLAY

TV [/1

TV t

batteries of different manufacturers.

 

– Do not attempt to recharge the batteries.

 

– If you do not intend to use the remote for an

extended period of time, remove the batteries.

– If battery leakage occurs, wipe out any liquid

inside the battery compartment, and insert new

batteries.

 

• Do not expose the remote sensor (marked

on

the front panel) to strong light, such as direct

 

sunlight or a lighting apparatus. The recorder

 

may not respond to the remote.

 

• When you replace the batteries of the remote, the

code number and Command Mode may be reset

to the default setting. Set the appropriate code

number and Command Mode again.

 

TV PROG +/–

1 Hold down TV [/1 located at the bottom of the remote.

Do not press the [/1 button at the top of the remote.

2 With TV [/1 pressed down, enter theTV’s manufacturer code using the number buttons.

For instance, to enter “09,” press “0” then “9.” After you enter the last number, release the TV [/1 button.

22