Easy Setup - Line3 Input (Analogue Mode only)
If you plan to connect a decoder such as
a
Easy Setup - Line1 Output
To output video signals, select “Video.” To output S video signals, select “S Video.”
To output RGB signals, select “RGB.” Select “Video” to enjoy the SMARTLINK features (page 20).
•If you set “Easy Setup - Component Out” to “On,” you cannot select “RGB.”
•If you set “Easy Setup - Line3 Input” to “Yes,” you cannot select “S Video.”
Easy Setup - Audio Connection
If you connected an AV amplifier (receiver) using either a digital optical or coaxial cord, select “Yes : DIGITAL OUT” and set the digital output signal (page 143).
3 Press ENTER when “Finish” appears.
“Easy Setup” is finished.
To receive GUIDE Plus+ system data your recorder must be turned off when not in use. If your recorder is connected to a set top box receiver, be sure to leave the set top box receiver turned on. After initial setup, it may take up to 24 hours to begin receiving TV programme listings.
To return to the previous step
Press O RETURN.
zHints
•If your AV amplifier (receiver) has an MPEG audio decoder, set “MPEG” to “MPEG” (page 143).
•If you want to run “Easy Setup” again, select “Easy Setup” from “SETUP” in the System Menu (page 151).
Setting up your set top box receiver for the GUIDE Plus+® system (Analogue Mode only)
Follow the steps below to set up your set top box receiver for the GUIDE Plus+ system. Note that the OSD language, Clock, Country and Postal Code are all set for the GUIDE Plus+ system when Easy Setup is completed.
1 Press GUIDE 
.
The GUIDE Plus+ system “Home Screen” appears.
2 Select “Setup” in the Menu Bar using M/,, and press ENTER.
The GUIDE Plus+ setup menu appears.
3 Select “Basic Setup” using M/m, and press ENTER.
4 Select “External Receiver 1,” and press ENTER.
You can also select “External Receiver 2” or “External Receiver 3” if you have connected additional set top box receivers.
5 Press ENTER to select “Continue.”
6 Select the set top box receiver type using M/m, and press ENTER.
7 Select the provider using M/m, and press ENTER.
8 Select the receiver brand using M/m, and press ENTER.
If you select “Other providers,” you can select a receiver brand from a list of all available brands.
If your receiver brand is not on the list, select “???.”
The receiver brand list is automatically updated, so your receiver may be available at a later date. Select your brand when it becomes available. Until then, use “???.”
28