To program the IR code to the USER RESERVE KEYS
1 Perform steps 1 to 5 of “To program an IR code to the preset operation keys”, then in step 6, select one of the USER RESERVE KEYS you want to program the IR code.
The LEARN screen appears.
Selected key | Message window |
Name input buttons
Command key
2 Touch LEARN.
“Please Send Signal.” appears. Perform step 3 within 30 seconds after the mark starts blinking.
3 Press the appropriate button on the remote control to send the remote control code.
Press the button more than 1 second. When this commander receives the remote control code and the learning is successful, “This key have code.” appears, and a mark (x) appears in the upper right corner of the key.
4 Touch EXIT.
5 Touch 
.
6 Touch USE in the
The commander returns to the operation mode.
To cancel learning
Touch CANCEL in step 2.
To clear the learned code
After step 3, touch CLEAR. “Clear?” appears. Then, touch “YES”. The learned code is cleared.
Tip
•You can test the USER RESERVE KEYS. Touch “TEST” after “This key have code.” appears in step 3. The learned code is sent from the commander, and if correct, the corresponding operation is performed.
•You can make a name of up to 14 characters for the USER RESERVE KEYS. Touch the name input buttons as displayed to enter the name.
•To ensure the proper learning, we recommend using new batteries in the remote to be learned.
Notes
•Normally, each remote (component) has 8 USER RESERVE KEYS. However, depending on the signals of the codes being learned, it may not be possible for the commander to store codes for all
USER RESERVE KEYS.
•Some remote control codes cannot be learned.
Using a command that has been learned
Select the key which has learned the command.
Operations Advanced