Programming signals of another remote control — Learning Function (continued)

2While holding x pressed, press the Component Select button you want to erase.

When erasing of a “learned” function has completed, all the other Component Select button lights turn off.

during data

data erasing

erasing

complete

Notes

•With this operation, you can only erase the “learned” functions of all buttons for a specific component.

•To erase a single “learned” function of a Component Select button, see page 22.

3Press SET to finish setting.

To cancel erasing, press SET.

Notes on programming the signals for an air- conditioner

About seasonal adjustments

If you change the settings of the air-conditioner for the season, you have to program the remote control signals of the new settings on the Commander.

If the power-on/off operation does not work correctly

If the Commander can only operate “ON” with one button and “OFF” with another, while your air-conditioner’s remote control can operate “ON/OFF” with a single button, program the signal on two buttons of the Commander as follows.

1Clear the “learned” power-on/ off signal on the programmed button of the Commander.

2Reprogram only the power-on signal of the air-conditioner on the button of the Commander by following the steps of “Programming signals of another remote control- Learning Function” (page 16).

3Program the power-off signal of the air-conditioner on another button of the Commander.

The two buttons of the Commander have been programmed with the power-on signal and the power-off signal of the air-conditioner respectively, so that you can operate the air- conditioner with the Commander.

24