Symptom | Possible Causes and Remedies |
|
|
Remote control doesn’t work | Y To operate your components, make sure you’ve programmed the remote |
| properly. See “Programming the Remote” on page 79. Note: The remote |
| codes may be erased whenever you remove the batteries. Program the |
| remote again if you’ve removed or replaced the batteries. |
| Y Press the appropriate FUNCTION button for the component you want to |
| operate. |
| Y Check to make sure the batteries are inserted correctly, and that the batteries |
| are not dead. See page 7. |
| Y RF problems: Check that the RF antenna is connected properly and that |
| you’re using the remote control within operating range of the DSS receiver |
| (see “Setting Up the RF Antenna” on page 22). Make sure that RF |
| transmission is enabled (see “Selecting IR/RF Transmission” on page 69). |
| Make sure the DSS receiver and remote control are using the same security |
| code (see“Setting the Security Code” on page 70). |
|
|
| If you are unable to resolve problems with your system, please see |
| “Customer Support” on page 2 for customer support information and |
| telephone numbers. |
Appendix: Other Information 85