73
Troubleshooting
Additional Information
filename[010ADDI.fm] model name1[SLV-SE250B] model name2[SLV-SE450B]
[3-868-346-E2 (1)]
Recording
No TV programme appears
on the TV screen. • Make sure the TV is set to the video channel. If you are using a
monitor, set it to video input.
• If your TV is connected to the VCR with both PERI TEL and aerial
cables, make sure the RF channel is set to OFF (see page 13).
• Existing broadcasts may interfere with the VCR. Reset the RF
channel output of your VCR.
• Select the correct source with the CHOIX ENTREE button. Select
a programme position when recording TV programmes; select
“L1” or “L2” when recording from other equipment.
TV reception is poor. • Make sure the aerial cable is connected securely.
• Adjust the TV aerial.
• Make sure NORME (L or B/G) in the REGLAGE DES CHAINES
menu is set to the same system used in your local area.
The tape starts playing as
soon as it is inserted. • The safety tab has been removed. To record on this tape, cover the
tab hole (see page 43).
The tape is ejected when
you press zENR. • The safety tab has been removed. To record on this tape, cover the
tab hole (see page 43).
Nothing happens when you
press zENR. • Make sure the tape is not at its end.
Timer recording
The timer does not operate. • Check that the clock is set.
• Make sure a tape has been inserted.
• Check that the safety tab has not been removed.
• Make sure the tape is not at its end.
• Make sure a programme has been set for timer recording.
• Make sure your timer settings are past the current time.
• Check that the decoder is turned on.
• Check that the satellite tuner is turned on.
• The clock stops if the VCR is disconnected from the mains for
more than one hour. Reset the clock and timer.
• Turn the power off and unplug the mains lead.
The SHOWVIEW menu or
the MINUTERIE menu
does not appear.
• Check that OPTIONS PROGRAMM. in the OPTIONS-2 menu is
set correctly (see page 68).
The VPS/PDC function
does not operate properly. • Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one (there
might be a mistake in the TV programme guide). If the broadcast
you wanted to record did not send the good VPS/PDC information,
the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be altered and
the VCR might not start recording.
Symptom Remedy
continued
010COV.book Page 73 Friday, April 14, 2000 1:07 PM