Sony STR-DE1015G, STR-DE815G, STR-D760Z operating instructions Erasing TV IR codes

Setting Up the Remote for On-Screen Control

7When “PUSH YOUR REMOTE” appears in the on-screen display, press the button on the TV's remote that corresponds to the highlighted control button (e.g., POWER).

•If your TV’s remote has an independent input selector button (e.g., VIDEO 1).

Register the IR code of this button when the VIDEO 1 button appears. When you turn on the receiver, the TV switches to the video input automatically.

•If your TV does not have an independent input selector button or has a cyclic input selector button.

Do not register an IR code of the input selector button. The TV’s input cannot be switched automatically when you turn on the receiver. Switch the TV to the video input manually. If you registered an IR code for the VIDEO 1 button, erase the VIDEO 1 code following the steps in “To erase a specific IR code” below.

•If you selected WIDE in step 4.

Register the IR code for the wide TV mode button on your TV’s remote when the WIDE TV DISPLAY MODE button appears.

	TV IR SET
TV IR SET		TV POWER
		VIDEO 1
PUSH	YOUR	REMOTE
	CODE CLEAR
RETURN		EXIT

For Australian and Singaporean models

The on-screen display also includes the following settings for your TV's remote control.

•TV/VIDEO : Use to program the cyclic input selector button on your TV’s remote. This allows you to switch the TV’s input selector using this unit’s remote. Do not program an independant input selector button at this setting.

•WIDE TV DISPLAY MODE: Use to program the wide TV mode button on your TV’s remote.

IR sensor

TV's remote

When registering the IR code, be sure to do the following; otherwise, the IR code may not be registered correctly.

•Point the remote at the IR sensor on the

receiver from a distance of less than 2 inches (5 cm).

•Hold down the button on the remote for about 2 or 3 seconds until the “RECEIVING” display switches to

“RELEASE YOUR REMOTE”.

•Keep the remote pointed horizontally at the IR sensor until the code is registered.

8Repeat step 7 for the remaining buttons that appear in the on-screen display.

If “NG” is displayed, an IR code was not registered correctly. In this case, repeat step 7 again.

To return to the main menu

Click EXIT.

To return to a previous menu

Click RETURN.

To exchange from a non-Sony TV to a Sony TV

Connect the receiver’s MONITOR OUT jack to the VIDEO 1 input jack of the Sony TV. Follow the registration steps 1 to 3, then click SONY TV in step 4. Click VIDEO 1 2 3 and/or WIDE to specify VIDEO 1 and/or WIDE if necessary.

Note

Some IR codes may not have been successfully registered, even if “RELEASE YOUR REMOTE” appears on the TV screen. In this case, try registering the IR code again. If the IR code still cannot be registered, follow the procedure described in “Registering Desired Components (User IR setting)” on page 42.

Erasing TV IR codes

Click CODE CLEAR in the TV IR SET menu that appears when you click START.

• To erase a specific IR code

1Click SINGLE IR CODE CLEAR.

2Click the button you want to clear. “Are you sure?” appears.

3Click YES to erase the code. To cancel erasing, click NO.

To erase another code repeat steps 2 and 3.

•To erase all the TV IR codes

1Click TV IR CODE CLEAR. “Are you sure?” appears.

2Click YES to erase the codes.

“CODE CLEAR!” appears in the display. To cancel erasing, click NO.

18