Sony STR-DE1015G, STR-DE815G, STR-D760Z operating instructions Click the respective component

Setting Up the Remote for On-Screen Control

5Click the respective component.

IR CODE SETTING
MAKER	Sony	OTHER
OUTPUT	IR
VCR	DVD	TAPE
TV	LD	DAT
	CD	MD

RETURN START EXIT

•If the component is not a VCR or laser disc player

1Cover the IR sensor on the component to prevent accidental operation during the registration procedure.

2Click START, then go to step 6.

•If the component is a VCR, DVD or laser disc player:

1	Click START.
	A list of other manufacturers appears.
		LD	DAT
		CD	MD
	RETURN	START	EXIT
2	Click the manufacturer of the component you
	want.
	The IR codes for that component are
	automatically registered.

VCR MAKER SETTING
EMERSON	1 2 3 4	AKAI	1 2
FISHER	1 2 3	GE	1 2
PANASONIC	1 2	JVC	1 2
TOSHIBA	1 2	RCA	1 2
MITSUBISHI	1 2 3	SANYO	1 2
GRUNDIG		SHARP
HITACHI		ZENITH
PHILIPS		OTHER
RETURN	TEST		EXIT

If the manufacturer is not listed, cover the IR sensor on the component to prevent accidental operation during the registration procedure, click OTHER, then go to step 6.

3Click TEST.

If the selected component turns on, the IR codes have been registered. The registration is complete.

If the component does not turn on: Click the number button beside the manufacturer’s name to select another number, then click TEST again.

If the component still does not turn on: Cover the IR sensor on the component to prevent accidental operation during the registration procedure is complete, click OTHER, then go to step 6.

6When “PUSH YOUR REMOTE” appears, press the button on your audio/video component's remote that corresponds to the control button highlighted.

is the POWER switch.

After you have registered all the IR codes, the IR CODE SETTING menu reappears.

		IR CODE SETTING
0	(	)	p	P	= +		1
2	3	4	5	6	7	8	9
10/0	>10	DISC		TRACK		ENTER
D. SKIP
	PUSH		YOUR		REMOTE
				CODE CLEAR
RETURN						EXIT

IR sensor

audio/video component's remote

When registering the IR code, be sure to do the following; otherwise, the IR code may not be registered correctly.

•Point the remote at the IR sensor on the

receiver from a distance of less than 2 inches (5 cm).

•Hold down the button on the remote for about 2 or 3 seconds until the “RECEIVING” display switches to

“RELEASE YOUR REMOTE”.

•Keep the remote pointed horizontally at the IR sensor until the code is registered.

7Repeat steps 3 to 6 to register IR codes from other components.

20