25
Dolby Pro Logic Surround SetupDolby Surround Setup
3Click C MODE repeatedly to display the center
mode appropriate for your speaker system (see
page 24).
4Click TEST.
You will hear a test tone from the speakers in the
following order. The speaker emitting the test
tone is shown in red on the SURROUND EDIT
menu.
WIDE, NORMAL: Front (left) n Center n
Front (right) n Rear
PHANTOM: Front (left and right) n Rear
3CH LOGIC: Front (left) n Center n Front (right)
5Adjust the volume levels so that you hear the test
tone from each speaker at the same volume level
when you are in your listening position:
• Click CENTER + or – to adjust the level of the
center speaker from –15.0 dB to +10.0 dB (1
dB/steps).
During this adjustment, the test tone is emitted
from the center speaker.
• Click REAR + or – to adjust the level of the rear
speakers from –15.0 dB to +10.0 dB (1 dB/
steps).
During this adjustment, the test tone is emitted
from both speakers simultaneously.
6Click TEST when you are done adjusting.
The test tone is turned off.
To return to the main menu
Click EXIT.
To return to a previous menu
Click RETURN.
You can adjust all speakers at one time
Use MASTER VOL on the remote.
You can increase the output level of the rear
speakers
You can raise the output of the rear speakers by 5 dB.
When turning on the receiver, press POWER and
MODE simultaneously to display “GAIN UP”. To
return the output level to normal, repeat this procedure
to display “GAIN NORMAL”.
SURROUND EDIT
DELAY
CENTER :
REAR :
+
–
LEVEL
C MODE
dB
dB
+
–
RETURN STANDARD EXIT
TEST
WOOFER
0
0
NORMAL
SURROUND EDIT
DELAY
CENTER :
REAR :
+
–
LEVEL
C MODE
dB
dB
+
–
RETURN STANDARD EXIT
TEST
WOOFER
0
0
NORMAL