To enjoy the best possible multi channel surround, connect speakers with a nominal impedance of 8 ohms or higher to the FRONT A or FRONT B, CENTER, SURR and SURR BACK terminals, and set the IMPEDANCE SELECTOR to “8Ω”. Use the screwdriver to set the impedance selector to the correct position. Refer to the operating instructions supplied with your speakers if you are not sure of their impedance. (This information is often on the back of the speaker.)
Alternatively, you may connect speakers with nominal impedances between 4 and 8 ohms to any or all of the speaker terminals. However, be sure to set the IMPEDANCE SELECTOR to “4Ω” if you connect even one speaker with a nominal impedance between 4 and 8 ohms.
If you connect speakers to both the SPEAKERS FRONT A and B terminals, be sure to set the IMPEDANCE SELECTOR and connect the appropriate speakers as follows:
Set IMPEDANCE SELECTOR to | and connect speakers with a nominal |
| impedance of |
|
|
4Ω | 8 ohms or higher |
|
|
8Ω | 16 ohms or higher |
|
|
For details on selecting the front speakers you want, see “Selecting the speaker system” (page 49).
Note
Be sure to turn the power off before adjusting the IMPEDANCE SELECTOR.