Press ALT to light up the button.
Changing the command mode of the receiver

This function is useful when you use 2 Sony receivers in the same room. Use the buttons on the receiver for the operation.

1 Turn off the receiver.2 Hold down INPUT MODE and press ?/1 to turn on the receiver.

“C.MODE.AVX” appears in the display. Each time you repeat the procedure above, the display changes as follows: C.MODE.AV1 y C.MODE.AV2

Tip

The initial setting is “C.MODE.AV2”.

Notes

•The initial setting for the command mode of the supplied remote is “AV2”.

•If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.

Using the Sleep Timer

You can set the receiver to turn off automatically at a specified time. Use the remote for the operation.

1

2 Press SLEEP repeatedly while the power is on.

Each time you press SLEEP, the display changes cyclically as follows:

2-00-00 t 1-30-00 t 1-00-00 t 0-30-00 t OFF

While using Sleep Timer, “SLEEP” lights up in the display.

Tip

To check the remaining time before the receiver turns off, press ALT to light up the button (page 52), then press SLEEP. The remaining time appears in the display. If you press SLEEP again, the sleep timer will be canceled.

48GB