Changing the display

Changing the information in the display

You can check the sound field etc. by changing the information in the display.

Press DISPLAY repeatedly.

Each time you press DISPLAY, the display will change cyclically as follows:

Index name of the inputa) t Selected input t Sound field currently applied t Volume level

When tuning in an FM/AM band

Program Service nameb) or index name of the preset stationa) t Frequency t Program Type indicationb) t Radio Text indicationb) t Current Time indication (in 24-hour system)b) t Sound field currently applied t Volume level

When tuning in a DAB station

Service Component Label t Frequency t Program Type indication t Dynamic label segment t Current Time indication (in 24-hour system)c) t Channel label t Audio Infod) t Signal Qualitye) t Sound field currently applied t Volume level

a)Index name appears only when you have assigned one to the input or preset station (page 47). Index name does not appear when only blank spaces have been entered, or it is the same as the input name.

b)During RDS reception only (page 29).

c)Time information appearing in the display is sent by the DAB station. As a result, the time may not be displayed properly if the station is located in a different time zone.

“– –H – –M” is displayed until the time information is received.

d)Audio information on bit rate (32kbps - 256kbps), signal type (stereo, dual, mono) and sampling type (F: 48kHz, H: 24kHz) is displayed.

Example: 128K S F

e)The DAB station sound quality is displayed. “Q. _ _ _” is displayed until the sound quality information is received.

Note

When “STEREO” appears in the display, the current programme is broadcasted in the stereo/joint (intensity) stereo mode.

Operation Amplifier

31GB