The surround effect cannot be obtained.

•Make sure the sound field function is on (press MOVIE or MUSIC).

•Sound fields do not function for the signals with a sampling frequency of more than 48 kHz.

Dolby Digital or DTS multi channel sound is not reproduced.

• Check that the playing DVD, etc. is recorded in

Dolby Digital or DTS format.

• When connecting the DVD player, etc. to the

digital input jacks of this receiver, check the audio

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Receiver

setting (settings for the audio output) of the

connected component.

Recording cannot be done.

• Check that the components are connected

correctly.

• Select the source component with INPUT

SELECTOR.

AM

COAXIAL

ANTENNA

Ground wire (not supplied)

• Make sure that INPUT MODE is set to

“ANALOG” (page 41) before recording from a

digital component connected to the analog MD/

TAPE jacks.

• Make sure that INPUT MODE is set to “COAX

IN” or “OPT IN” (page 41) before recording from

a digital component connected to the DIGITAL

OPTICAL MD/TAPE OUT jack.

You cannot name the preset station.

• You cannot name DAB/FM RDS stations.

“DAB _ _ _ _” appears in the display (DAB reception only).

•Check all antenna connections, then press TUNING + or TUNING – to select a service.

•The current DAB service is not available. Press TUNING + or TUNING – to select a different service.

•If you have moved to another area, some services/ frequencies may have changed and you may not be able to tune into your usual broadcast. Perform the DAB INITIAL SCAN procedure to re-register the contents of broadcast. (Performing this procedure clears all previously stored presets.) (page 27).

To ground

Radio stations cannot be tuned in.

•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 28).

•Press DISPLAY repeatedly so that the frequency appears in the display.

RDS does not work.

•Make sure that you’re tuned to an FM RDS station.

•Select a stronger FM station.

The RDS information that you want does not appear.

•Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.

62GB