Sony STR-DE525, STR-DE625 manual 11

CONTROL S hookup (STR-DE625 only)

If you have a CONTROL S-compatible Sony TV, DBS tuner, monitor, or VCR, use an audio/video/control S connecting cord (supplied) or a control S connecting cord (supplied) to connect the CTRL S (STATUS) IN (for TV, DBS tuner, or monitor) or OUT (for VCR etc.) jack on the receiver to the appropriate S-LINK jack on the respective component. Refer to the operating instructions supplied with your TV, DBS tuner, monitor, VCR, etc., for details.

An example of a CONTROL S hookup between the receiver and TV or VCR is shown below.

When your TV is connected to the receiver as shown below, the TV input mode will change to video input whenever you turn on the receiver.

When you connect the VCR to the receiver as shown below, the input mode of the receiver changes to video 1 (or 2) whenever you turn on the VCR.

TV
AUDIO			VIDEO
OUT	S-LINK		IN
	IN	OUT
	L
	R

	*	**		*
Receiver	TV / DBS	VIDEO 1		MONITOR
	CTRL S	CTRL S		CTRL S
	STATUS IN	OUT		IN
		S-LINK
	VIDEO	VIDEO	VIDEO	VIDEO
	IN	OUT	IN	OUT
	AUDIO	AUDIO	AUDIO
	IN	OUT	IN
	L			L
	R			R

		*
VCR		OUTPUT
		OUT
		VIDEO
	S-LINK	AUDIO
	OUT
		OUT
		L
		R

*Audio/video/control S connecting cord

**Control S connecting cord

CONTROL A1 hookup (STR-DE625 only)

• If you have a CONTROL A1-compatible Sony CD	Hooking
player, tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the	Up
S-LINK CTRL A1 jack on the CD player, tape deck, or
MD deck to the S-LINK CTRL A1 jack on the receiver.	the
See “Displaying the operating status of the component
connected to the S-LINK CTRL A1 jack” on page 36 and	Components
• If you have a Sony CD changer with a
refer to the separate manual “CONTROL-A1 Control
System” and the operating instructions supplied with
your CD player, tape deck, or MD deck for details.
COMMAND MODE selector
If your CD changer’s COMMAND MODE selector can
be set to CD 1, CD 2, or CD 3, be sure to set the
command mode to “CD 1” and connect the changer to
the CD jacks on the receiver.
If, however, you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to “CD 2” and
connect the changer to the VIDEO 2 jacks on the
receiver.
Setting the voltage selector (only on
models supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
receiver is set to the local power supply voltage. If not,
use a screwdriver to set the selector to the correct position
before connecting the AC power cord to a wall outlet.

VOLTAGE SELECT

220V

240V

120V

11