Selecting the impedance (STR-DE625 only)

Set the IMPEDANCE SELECTOR for the front speakers as indicated in the table below. Check the instruction manual of your speakers if you’re not sure of the impedance. (This information is usually printed on a label on the back of the speaker.)

If the nominal impedance of

Set IMPEDANCE SELECTOR to

your speaker is

 

 

 

Between 4 and 8 ohms

4Ω

 

 

8 ohms or higher

8Ω

 

 

Note

Be sure to connect the front speakers with nominal impedance of 8 ohms or higher if you want to select both sets of front speakers (see page 21).

Dolby Surround Setup

Dolby Pro Logic Surround is a system for decoding Dolby Surround sound that is standardized for TV programs and movies. By selecting the proper center mode and adjusting the speaker volume (see page 16), you can reproduce highly precise localization and dynamic panning of sounds of Dolby Pro Logic Surround- encoded software.

To obtain the best possible surround effect, you will require at least one additional pair of speakers and/or a center speaker.

Locating the speakers

For optimum Dolby Pro Logic Surround sound, locate your speakers as shown below.

Front speakers

Center speaker 45°

Rear speakers

Rear speaker

 

21/2 to 31/2 in. (60 - 90 mm)

Front speaker

System Speaker the Up Setting and Up Hooking

15