Information Additional
Troubleshooting
The left and right sounds are unbalanced or reversed.
/Check that the speakers and components are connected correctly and securely.
/Adjust the BALANCE control.
Severe hum or noise is heard.
/Check that the speakers and components are connected securely.
/Check that the connecting cords are away from a transformer or motor, and at least 10 feet (3 meters) away from a TV set or fluorescent light.
/Move your TV away from the audio components.
/Make sure you’ve grounded SIGNAL GND y terminal.
/The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
Recording cannot be done.
/Check that the components are connected correctly.
/Select the source component with a FUNCTION button.
/You cannot record audio from a program source connected to the 5.1/DVD INPUT jacks.
Radio stations cannot be tuned in.
/Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.
/The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.
/Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning) (see pages 30 and 40).
/No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (see page 31).
/Press the DISPLAY button so that the frequency appears in the display.
The surround effect cannot be obtained.
/Turn on the sound field function.
/Make sure that the SPEAKERS selector is set to A or B when you use two sets of front speakers.
No picture or an unclear picture appears on the TV screen or monitor.
/Select the appropriate function on the receiver.
/Press the TV/VIDEO button on the supplied remote to set your TV to the appropriate input mode.
/Move your TV away from the audio components.
The remote does not function.
/Point the remote at the remote sensor gon the receiver.
/Remove any obstacles in the path between the remote and the receiver.
/Replace both batteries in the remote with new ones, if they are weak.
/Make sure you select the correct function on the remote.
/Pressing the TV CONTROL button sets the remote to operate the TV only. If this mode is on, press one of the FUNCTION buttons on the receiver or a function button on the remote before operating the receiver or another component.
Reference pages for clearing the receiver’s
memory
To clear | See page |
All the contents of memory | 17 |
|
|
Customized sound fields | 27 |
|
|
38