Press TUNER.
The last received station is tuned in.

Preset tuning (continued)

Presetting radio stations

1

2 Tune in the station that you want to preset using Direct Tuning (page 32) or Automatic Tuning (page 33).

3 Press MEMORY.

“MEMORY” appears in the display for a few seconds.

Do steps 4 to 6 before “MEMORY” goes out.

4 Press SHIFT to select a memory page (A, B or C).

Each time you press SHIFT, the letter “A”, “B”, or “C” appears in the display.

5 Press PRESET TUNING +* or PRESET TUNING –* to select a preset number.

If “MEMORY” goes out before you press the preset number, start again from step 3.

6 Press MEMORY again to store the station.

If “MEMORY” goes out before you can store the station, start again from step 3.

7 Repeat steps 2 to 6 to preset another station.

*For models of area code CEL, CEK: PRESET/PTY SELECT + or PRESET/PTY SELECT –.

To change a preset number to another station

Do steps 1 to 6 to preset a new station to the number.

Tuning to preset stations

You can tune the preset stations by either of the following two ways.

Scanning the preset stations

1 Press TUNER.

The last received station is tuned in.

2 Press PRESET TUNING +* or PRESET

TUNING –* repeatedly to select the preset station you want.

Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:

nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N

nC0˜...C2˜C1N

*For models of area code CEL, CEK: PRESET/PTY SELECT + or PRESET/PTY SELECT –.

Using the preset codes

Use the supplied remote to perform the following operations. For details on the buttons used in this section, see pages 42–48 for remote RM-PP411 and pages 49–52 for remote RM-U305C.

1 Press TUNER on the remote.

The last received station is tuned in.

2 Press SHIFT to select a memory page (A, B, or C), then press the preset number of the station you want using the numeric buttons.

34GB