Programming the remote
You can program the remote to control non- Sony components by changing the code. Once the control signals have been memorized, you can use those components as part of your system.
Furthermore, you can also program the remote for Sony components that the remote is unable to control. Note that the remote can only control components that accept infrared wireless control signals.
1 Press AV ?/1 while pressing down USE MODE.
The indicator lights.
2 Press the function button (including TV ?/1) for the component you want to control.
For example, if you are going to control a CD player, press CD/SACD.
3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code exists) corresponding to the component and the maker of the component you want to control.
See the tables on pages 47 and 48 for information on the numeric code(s) corresponding to the component and the maker of the component (the first digit and the last two digits of the numeric code correspond to the category and the maker’s code respectively.)
4 Press ENTER.
Once the numeric code has been verified, the indicator slowly flashes twice and the remote automatically exits the programming mode.
5 Repeat steps 1 to 4 to control other components.
To cancel programming
Press USE MODE during any step. The remote automatically exits the programming mode.
To activate the function after programming.
Press the programmed button to activate the function you want.
If programming is unsuccessful, check the following:
•If the indicator does not light up in step 1, the batteries are weak. Replace both batteries.
•If the indicator flashes 4 times in quick succession while entering the numeric code, an error has occurred. Start again from step 1.
Notes
•The indicator turns off while a valid button is pressed.
•In step 2, if several function buttons are pressed, only the last pressed button is valid.
•In step 2, if you press TV ?/1, only TV VOL
•In step 3, if a function button is pressed, the new function is selected and the programming procedure returns to the beginning of step 3.
•For the numeric codes, only the first three numbers entered are valid.
To clear the memory of the remote
To clear all programmed and learned signals, do the following to reset the remote to factory settings.
Press ?/1, AV ?/1 and MASTER VOL – at the same time.
The indicator flashes 3 times, then goes off.