Remote button description (continued)
Remote | Operations | Function |
Button |
|
|
|
| |
POSITION**TV | Changes the position of | |
|
| the small picture. |
|
|
|
SWAP** | TV | Swaps the small and the |
|
| large picture. |
|
|
|
SUB CH | TV | Selects the preset |
| channels for the small | |
|
| picture. |
|
|
|
P IN P** | TV | Activates the |
|
| picture function. |
|
|
|
JUMP | TV | Toggles between the |
|
| previous and the current |
|
| channels. |
|
|
|
WIDE | TV | Selects the wide picture |
|
| mode. |
|
|
|
TV/VIDEO | TV | Selects input signal: TV |
|
| input or video input. |
|
|
|
**Only for Sony TVs with the
Notes
•When you press the function buttons (VIDEO 1, VIDEO 2, VIDEO 3, DVD/LD), the input mode of the TV might not switch to the corresponding input mode that you want. In this case, press the TV/ VIDEO button to switch the input mode of the TV.
•Some functions explained in this section may not work depending on the model of the receiver.
•The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described.
•The TV/SAT and PHONO functions are not available for set operation.
Changing the factory
setting of a function button
If the factory settings of the FUNCTION buttons do not match your system components, you can change them. For example, if you have an MD player and a tape deck and you don’t have a CD player, you can assign the CD/SACD button to your tape deck.
Note that the settings of the TUNER and FN SHIFT functions (VIDEO 1, VIDEO 2, VIDEO 3, PHONO and MD/TAPE) button cannot be changed.
1 Hold down the Function button whose function you want to change (for example, CD/SACD).
2 Press the corresponding button of the component you want to assign to the Function button (for example, 4 – Tape deck).
The following buttons are assigned to select the functions:
To operate | Press |
CD player | 1 |
|
|
DAT deck | 2 |
|
|
MD deck | 3 |
|
|
Tape deck A | 4 |
|
|
Tape deck B | 5 |
|
|
LD player | 6 |
|
|
VCR (command mode VTR 1*) | 7 |
|
|
VCR (command mode VTR 2*) | 8 |
|
|
VCR (command mode VTR 3*) | 9 |
|
|
TV | 0 |
|
|
DSS (Digital Satellite Receiver) | >10 |
|
|
DVD | ENTER |
|
|
VCD player | . |
|
|
*Sony VCRs are operated with a VTR 1, 2 or 3 setting. These correspond to Beta, 8mm and VHS respectively.
Now you can use the CD/SACD button to control the tape deck.
To reset a button to its factory setting
Repeat the above procedure.
To reset all the function buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the same time.