Note
Depending on the characteristics of the sub woofer you are using, the setup distance value may be further away from the actual position.
Using the receiver as a pre- amplifierYou can use the auto calibration function when you use the receiver as a
In this case, the distance value shown on the display may differ from the actual distance value. However, there will be no problems even if you continue to use the receiver with that value.
2
1
3
4
The auto calibration function allows you to measure the following:
•Whether or not speakers are connecteda)
•Terminal types of speakers connected
•Distance of each speaker from your listening positionb)
•Speaker sizeb)
•Speaker level
•Frequency characteristicsc)
a)This receiver corrects signals by analog downmix processing only for the center speaker and sub woofer when MULTI IN is selected. The
correction is invalid for other speakers.
b)The measurement result is not utilized when MULTI IN is selected.
c)• DTS 96/24 signals are always played back as 48 kHz when you correct signals.
•The measurement result is not utilized in the following cases.
–MULTI IN is selected.
–Input signals of which the sampling frequency is more than 96 kHz are being received.
1 Turn on the receiver and the TV.
2 Press ON SCREEN.
Switch the input of the TV so that the setting menu is displayed on the TV screen connected to this receiver.
3 Press RECEIVER.
Receiver operation is enabled.
4 Press MENU.
The list of setting menus appears.
5 Press V/v repeatedly to select “Auto Calibration,” then press to enter the menu.
42GB