Error code

Cause and remedies

CODE 33 (SR)

• Either the left or right surround

 

speakers is not connected.

 

• Surround back speakers are

 

connected even though

 

surround speakers are not

 

connected. Connect the

 

surround speaker to the

 

SURROUND terminal.

 

 

CODE 33 (SB)

The surround back speaker is

 

connected only to the

 

SURROUND BACK

 

SPEAKERS R terminal. When

 

you connect only one surround

 

back speaker, connect it to the

 

SURROUND BACK

 

SPEAKERS L terminal.

 

 

•CODE 31

1Press , then follow the instructions from step 1 of “Performing the auto calibration.”

•CODE 32, 33

1When you press , “RETRY?” appears.

2Press V/v to select “YES,” then press .

3Follow the instructions from step 2 of “Performing the auto calibration.”

4Press V/v repeatedly to select preset number to store preset settings then press .

When you select “WRN CHECK”

If a warning on the measurement result is present, detailed information is displayed.

Press to return to step 1 of “Confirming/saving the measurement results.”

Warning code Explanation

WARNING 40 The auto calibration has completed. However, the noise level is high. You may be able to perform the auto calibration properly if you try it again, even though the measurement cannot be performed in all environments. Try to perform the auto calibration in a quiet environment.

Warning code

Explanation

 

 

 

WARNING 41

The sound input from the

 

Getting

 

optimizer microphone is outside

 

the acceptable range. It is louder

 

 

 

than the loudest sound that can be

 

 

measured. Try to perform the auto

Started

 

calibration when the environment

 

 

 

is quiet enough to allow proper

 

 

measurement.

 

 

 

 

 

WARNING 42

The volume of the receiver is out

 

 

of the acceptable range. Try to

 

 

perform the auto calibration when

 

 

the environment is quiet enough

 

 

to allow proper measurement.

 

 

 

 

 

WARNING 43

The distance and position of a sub

 

 

woofer cannot be detected. Or the

 

 

angle of the speaker position

 

 

cannot be detected. This may be

 

 

caused by noise. Try to perform

 

 

the auto calibration in a quiet

 

 

environment.

 

 

 

 

 

NO WARNING

There is no warning information.

 

 

 

 

 

When you select “PHASE INFO”

You can check the phase of each speaker (in phase/out of phase).

Press V/v repeatedly to select a speaker, then press to return to step 1 in “Confirming/saving the measurement results.”

continued

45GB