6 Press V/v repeatedly to select “CAL TYPE,” then press to enter the parameter.
7 Press V/v repeatedly to select the parameter, then press to enter the selection.
Calibration | Explanation |
type |
|
|
|
ENGINEER | Sets the frequency |
| characteristics to a set that |
| matches that of the Sony |
| listening room standard. |
|
|
FULL FLAT | Makes the measurement of |
| frequency from each |
| speaker flat. |
|
|
FRONT REF | Adjusts the characteristics |
| of all the speakers to match |
| the characteristics of the |
| front speaker. |
8 Press V/v repeatedly to select “AUTO CAL START,” then press to start the measurement.
Measurement starts in five seconds. A countdown appears on the TV screen.
While the time is counting down, stand away from the measurement area to avoid measurement error.
9 Measurement starts.
Started Getting
The measurement process will take approximately 30 seconds. Wait until the measurement process completes.
Note
You cannot measure the speaker height of the surround speakers and the surround back speakers. Set this value from “SP POSI.” settings in the Speaker Settings menu (page 69).
Tips
•Operations other than turning the receiver on or off and pressing ON SCREEN to turn the display on or off are deactivated during auto calibration.
•In the following situations, the measurements may not be performed correctly or auto calibration cannot be performed.
–when special speakers, such as dipole speakers are used.
–when the multi zone function is used in zone 2.
To cancel auto calibrationAuto calibration is cancelled when you change the volume, switch functions, change the speaker setting of the receiver, or connect headphones.
43GB