Using the Remote
Changing button assignments
You can change the factory settings of the input buttons to suit the components in your system. For example, if you connect a DVD recorder to the VIDEO 1 jacks on the receiver, you can set the VIDEO 1 button on this remote to control the DVD recorder.
1 Hold down the input button of which you want to change the assignment.
Example: Hold down VIDEO 1.
2 Referring to the table below, press the corresponding button for the category you want.
Example: Press 4.
Now you can use the VIDEO 1 button to control the DVD recorder.
Categories and the corresponding buttons
Categories | Press |
VCR (command mode VTR 3)a) | 1 |
VCR (command mode VTR 2)a) | 2 |
DVD player/DVD recorder | 3 |
(command mode DVD1)b) |
|
DVD recorder | 4 |
(command mode DVD3)b) |
|
CD player | 5 |
|
|
MD deck | 6 |
|
|
Tape deck B | 7 |
|
|
Tuner (this receiver) | 8 |
|
|
DVR (Digital CATV terminal) | 9 |
|
|
DSS (Digital Satellite Receiver) | 0/10 |
a)Sony VCRs are operated with a VTR 2 or VTR 3 setting which correspond to 8 mm and VHS respectively.
b)Sony DVD recorders are operated with a DVD1 or DVD3 setting. For details, refer to the operating instructions supplied with the DVD recorders.
To clear all remote button assignments
Press ?/1, TEST TONE and MASTER VOL – at the same time.
The remote is reset to its factory settings.
40GB