Error messages

If there is a malfunction, the display shows a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.

DEC. EROR

Appears when a signal the receiver cannot decode (ex. DTS-CD) is input and “DEC. PRI.” is set to “DEC. PCM”. Change the setting to “DEC. AUTO” (page 26).

PROTECT

Irregular current is output from the receiver. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.

If you are unable to remedy the problem using the troubleshooting guide

Clearing the receiver’s memory may remedy the problem (page 19). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver.

If the problem persist

Consult your nearest Sony dealer. Note that if service personnel changes some parts during repair, these parts may be retained.

Reference sections for clearing the receiver’s memory

To clear

See

All memorized settings

page 19

 

 

Customized sound fields

page 32

 

 

Specifications

Amplifier section

Stereo Power Output1), Reference Power Output1)2)

8 ohms 20 Hz – 20 kHz, THD 0.09%

90 W + 90 W, 110 W/ch

8 ohms 1 kHz, THD 0.7%

105 W + 105 W, 120 W/ch

8 ohms 1 kHz, THD 10%

130 W + 130 W, 160 W/ch

1)Measured under the following conditions:

230 V AC, 50 Hz

2)Reference power output for front speakers. Depending on the sound field settings and the source, there may be no sound output.

Frequency response

 

 

Analog

10 Hz – 70 kHz

 

 

+0.5/–2 dB (with sound

 

 

field and tone bypassed)

 

Inputs

 

 

Analog

Sensitivity: 500 mV/

 

 

50 kohms

 

 

S/N3): 96 dB

 

 

(A, 500 mV4))

 

Digital (Coaxial)

Impedance: 75 ohms

 

Outputs (Analog)

S/N: 100 dB

Additional

(A, 20 kHz LPF)

 

 

Digital (Optical)

S/N: 100 dB

 

 

(A, 20 kHz LPF)

Information

AUDIO OUT

Voltage: 500 mV/10 kohms

 

SUB WOOFER

Voltage: 2 V/1 kohm

 

Tone

 

 

Gain levels

±6 dB, 1 dB step

 

3)INPUT SHORT (with sound field and tone bypassed).

4)Weighted network, input level.

continued

45GB