The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Receiver

ANTENNA

AM

Ground wire (not supplied)

To ground

Radio stations cannot be tuned in.

•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning (page 33).

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 35).

•Press DISPLAY repeatedly on the receiver so that the frequency appears on the display.

RDS does not work.

•Make sure that you are tuned to an FM RDS station.

•Select a stronger FM station.

The RDS information that you want does not appear.

•Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.

There is no picture or an unclear picture appears on the TV screen or monitor.

•Make sure you have connected the video output of your video component to the TV.

•Move your audio components away from the TV.

Remote control

The remote does not function.

•Point the remote at the remote sensor on the receiver.

•Remove any obstacles in the path between the remote and the receiver.

•Replace all the batteries in the remote with new ones, if they are weak.

•Make sure you select the correct input on the remote.

44GB