Preset tuning
After you have tuned in stations using Direct Tuning or Automatic Tuning, you can preset them to the receiver. Then you can tune in any of the stations directly by entering its
Before tuning to preset stations, be sure to preset them by performing steps on “Presetting radio stations”.
Presetting radio stations
1 Press TUNER.
2 Tune in the station that you want to preset using Direct Tuning or Automatic Tuning (page 23).
3 Press MEMORY.
“MEMORY” appears in the display for a few seconds.
Do steps 4 to 5 before “MEMORY” goes out.
4 Press PRESET + or PRESET – to select a preset number.
If “MEMORY” goes out before you press the preset number, start again from step 3.
5 Press MEMORY again to store the station.
If “MEMORY” goes out before you can store the station, start again from step 3.
6 Repeat steps 2 to 5 to preset another station.
Tuning to preset stations
You can tune the preset stations by either of the following two ways.
Scanning the preset stations
1 Press TUNER.
The last received station is tuned in.
2 Press PRESET + or PRESET – repeatedly to select the preset station you want.
Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as
follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
Using the preset codes
Use the supplied remote to perform the following operations. For details on the buttons used in this section, see page
1 Press TUNER.
The last received station is tuned in.
2 Press SHIFT to select a memory page (A, B, or C), then press the preset number of the station you want using the numeric buttons.
Tip
You can also use PRESET TUNING +/– on the receiver to tune to preset stations.