,Turn on the recorder.

,The remote is not pointed at the remote sensor on the recorder.

,Different command modes are set for the recorder and remote. Set the same command mode (page 12). The default command mode setting for this recorder and the supplied remote is HDD 1.

Specifications

System

Transmission standards: DVB-T

Other Sony equipment responds to the remote.

,The same command mode is set for both the equipment and recorder. Set a different command mode for the recorder (page 12).

Others

The recorder does not operate properly.

,Restart the recorder.

,When static electricity, etc., causes the recorder to operate abnormally, turn off the recorder. Then, unplug the recorder from the mains and after leaving it off for a while (10 seconds minimum), plug it in again.

,Check that the vent under the recorder is not blocked. Then, immediately disconnect the mains lead. Leave the recorder off for a while, then re-connect the mains lead, and press [/1 on the recorder.

“OAD” or “EPG” appears in the front panel display.

,This happens at night time around 3:00.

If the recorder remains at this state for more than two hours, the unit may have experienced a problem in downloading a programme guide or software update. Turn off the recorder, unplug the recorder from the mains, and after leaving it off for a while (10 seconds minimum), plug it in again.

Mechanical sound is heard when the recorder is off.

,The unit contains both a Hard Disk Drive and a cooling fan which runs continuously. Therefore, operational noise may be heard, even when the power is off. This is not a malfunction.

Channel coverage: UHF channels B21 - B69

The above channel coverage merely ensures the channel reception within these ranges. It does not guarantee the ability to receive signals in all circumstances.

Aerial out: 75-ohm asymmetrical aerial socket

Video recording format: MPEG Video

Inputs and outputs

LINE 1 - TV: 21-pinCVBS/S-Video/RGB OUT

LINE 2 - VCR / STB: 21-pin

CVBS IN/OUT

S-Video IN/OUT RGB IN

AUDIO OUT: Phono stereo jack L/R

General

Power requirements:

Mains adapter input: 110-240 V AC, 50/ 60 Hz

Recorder input: DC 12 V , 1,8A Power consumption: 30 W (maximum) Dimensions (approx.): 362 ⋅ 52 ⋅ 252 mm

(width/height/depth) incl. projecting parts Hard disk drive capacity: 80 GB (approx.)

Mass (approx.): 2.5 Kg

Operating temperature: 5ºC to 35ºC

Operating humidity: 25% to 80%

Supplied accessories:

AC power adapter (1)

Power cord (1)

Remote commander (remote) (1)

R6 (size AA) batteries (2)

Specifications and design are subject to change without notice.

Information Additional

49