5 Select “Command Mode.”
SETUP | 12:15 | |
| Features | Setting |
|
|
|
| Record Subtitles | Off |
| Subtitle Language | English |
| Interactivity | On |
| Sleep Timer | 0 |
| Front Panel | On |
| Command Mode | HDD 1 |
| Format HDD |
|
| Factory Setup |
|
6 Press </, to select the desired mode (HDD 1, HDD 2, or HDD 3).
A message appears and indicates that the Command Mode has changed.
7 Set the Command Mode for the remote so it matches the Command Mode for the recorder you set above.
Follow the steps below to set the Command Mode on the remote.
AHold down ENTER.
BWhile holding down ENTER, enter the Command Mode code number using the number buttons.
Command Mode | Code number |
HDD 1 | 1 |
|
|
HDD 2 | 2 |
|
|
HDD 3 | 3 |
CHold down both the number and ENTER buttons at the same time for more than three seconds.
If the Command Mode for the recorder has not been changed, set the Command Mode for the remote to the default setting of HDD 1. If the Command Mode for the remote is changed to HDD 2 or HDD 3, you will be unable to operate this recorder.
Step 6: Auto Tuning (Full Channel Scan)
Once the Sony Hard Disk recorder has been | Hookups |
start searching for all of the receivable TV and | |
connected to the mains for the first time, follow |
|
the |
|
Radio channels in your local area. | and |
[/1 | Settings |
|
ENTER
1 Turn on the recorder and switch the input selector on your TV so that the signal from the recorder appears on your TV screen.
The welcome message about the initial settings appears.
•If this message does not appear, select “DTV Settings” from “SETUP” in the System Menu to run “Auto Tune”. See page 41.
2 Press ENTER.
The recorder will automatically capture and store the available TV and Radio channels.
3 Press ENTER when “Scan Done” appears on the front panel display.
Auto Tuning is finished.
zHint
If a new channel is launched or your aerial is realigned you may need to
13