Hookups and Settings
Hooking Up the Recorder
Follow steps 1 through 6 to hook up and adjust the settings of the recorder. Do not connect the mains lead until you reach “Step 4: Connecting the Mains Lead” on page 10.
bNotes
•See “Specifications” (page 49) for a list of supplied accessories.
•Plug cords securely to prevent unwanted noise.
•Refer to the instructions supplied with the components to be connected.
•You cannot connect this recorder to a TV that does not have a SCART or video input jack.
•Be sure to disconnect the mains lead of each component before connecting.
Settings and Hookups
Step 1: Connecting the Aerial Cable
Connect the aerial cable by following the steps below.
Hard disk recorder
to RF IN
TV
to RF OUT
Aerial cable (not supplied)
: Signal flow
1 Disconnect the aerial cable from your TV and connect it to AERIAL IN on the rear panel of the recorder.
2 Connect AERIAL OUT of the recorder to the aerial input of your TV, using an optional aerial cable.
7