There is no sound.
,
,The connecting cord is damaged.
,The input source setting on the amplifier or the connection to the amplifier is incorrect.
,The recorder is in reverse play,
,A scrambled channel is selected.
,The volume MUTING button has been pressed.
The sound volume is low.
,Check and adjust the audio output level in “Video and Audio Settings (Options)” setup (page 43).
Sound break up
,Signal strength low.
,Check aerial installation.
PlaybackThe recorder does not play.
,Moisture has condensed inside the recorder. Leave the recorder turned on for about half an hour until the moisture evaporates.
The language for the sound track cannot be changed.
,Not all broadcasts carry multilingual language tracks. In that case you can only listen in the default language.
TV Pause does not work.
,Two simultaneous programmes are currently recording to the HDD or the HDD is full.
Recording/Timer recording/ EditingThe programme position cannot be changed from the programme position you are recording.
,Set the TV’s input source to “TV.”
,When two simultaneous programmes are currently recording to the HDD, you can only watch one of these two channels or play a title from the Title List.
Nothing was recorded even though you set the timer setting correctly.
,There was a power failure during recording.
,Disconnect the mains lead from the mains for at least 10 seconds, and connect it again.
,There is not enough disk space for the recording.
,A scrambled or teletext channel was selected.
,Parental Lock has been activated (page 40).
Recording does not stop after you press x.
,You may have to press x REC STOP.
Timer recording is not complete or did not start from the beginning.
,There was a power failure during recording. If the power recovers when there is a timer recording, the recorder resumes recording.
,Disk space was not enough.
,The broadcast schedule changed.
One Touch Recording does not start after you press z REC
,One Touch Recording is not possible if no TV Guide information is available for the particular programme. In this case you can record the programme by setting the timer manually (page 26).
,There is not enough disk space for the recording.
,The programme overlaps with two other timer settings.
DisplayThe TIMER REC indicator is flashing.
,The HDD does not have enough space.
The clock does not appear in the front panel display.
,The front panel lighting has been set to “Off” (page 44).
Remote controlThe remote does not function.
,Batteries are weak.
,The remote is too far from the recorder.
,The remote’s manufacturer code returned to the default setting when you replaced the batteries. Reset the code (page 11).
48