Note
Be sure to remove all of the seals attached to the paper roll. A seal remaining inside the printer may cause problems.
5 Close the cover.
Confirm that the tip of the paper appears.
If the tip of the paper protrudes from the platen roller, be sure to insert the tip of the paper under the rollers.
Rollers | Platen roller | |
|
|
|
|
|
|
|
|
|
|
|
|
Note
Do not touch the printing surface of the paper roll in the paper holder after loading it. Sweat or dust from your hands may have an influence on the quality of the printout.
6 Hold both spools and push the blue spool into the blue spool holders.
Insert the left side of the blue spool first, then the right side and push it until it clicks.
Caution
Since the thermal head is still very hot just after printing is finished, be careful not to touch the thermal head when loading the ink ribbon.
7 Detach the pink spool from the blue spool. Pull it upward and wind it until the transparent part (the laminating part) comes to the position illustrated, and push it into the pink spool holders.
Insert the left side of the pink spool first, then the right side and push it until it clicks.
The black marks should show on the front of the pink spool.
Transparent part (the laminating part)
Operation
Loading the Paper and Ink Ribbon | 11 |
|
|