Sony UP-DR100 Supplied Accessories, Assembly, Preparation, To remove the Paper scrap tray

Preparation	Assembly
	Mount the paper scrap tray on the printer.

Supplied Accessories

Make certain you have received the following accessories:

Preparation Paper Scrap Tray (1)

Power Cord (1)

CD-ROM (1)

Operating Manual (1)

Software License Agreement (1)

Warranty Card (1)

Service and Customer Support

Information (1)

Notes

•When taking out the printer, be careful not to hurt your back.

•The packaging materials are needed when transporting the printer, so we suggest you keep them.

•Before moving the printer, remove the ink ribbon and paper.

Paper scrap tray

To remove the Paper scrap tray

Hold both ends of the paper scrap tray and pull it forward while pushing it down.

To accumulate the ejected printed sheets Use of the UPA-DR100PS PRINT STACKER (not supplied) is recommended. Printed sheets for up to one roll can be accumulated on the stacker regardless of the type of printing pack used.

Caution

When the UPC-R57/R57A/R68A printing pack is used, check the location where the printer has been installed. A space of about 20 cm (7 7/8 inches) out from the printer, and about 20 cm (7 7/8 inches) down from the bottom of the printer is required as shown in the diagram.

Match the front edge of the printer to the edge of the installation rack.

7 7/8 inches

7 7/8 inches

If there is not enough space (as shown in the illustration above), ejected printed sheets may pile up and clog at the Paper Output Slot and trouble may occur.

6 Supplied Accessories